Installing exposed wiring in your home can allow you to highlight the industrial design aesthetic. However, exposed electrical work poses safety risks if not done properly. Follow these guidelines to safely run exposed wires without creating fire hazards.
Research Local Building Codes
The first step is to research your local building codes to understand legal requirements for exposed electrical work.
-
Contact your city's permit office to ask about restrictions and required permits for exposed wiring projects.
-
Consult the National Electrical Code for standards on proper installation methods.
-
Work with an electrician to ensure your plans meet requirements. Attempting electrical work without proper training and licensing is dangerous.
Choose the Right Gauge Wire
Select wiring that is thick enough to safely handle the level of electricity.
-
For lighting circuits, use 14 or 12 AWG for 15 amp circuits.
-
For 20 amp small appliance circuits, use 12 AWG wire.
-
For larger 30 amp appliance circuits, use 10 AWG.
-
When in doubt, choose a heavier gauge for safety.
-
Inspect wires for damage before installing.
Install Proper Firestops
Firestops are fire-resistant barriers required where wires penetrate walls and floors.
-
Choose metal, rockwool, or fire-rated putty firestops.
-
Seal all openings around wires to contain fires.
-
Install firestops on both sides of walls.
-
Use firestop grommets when passing wiring through metal studs.
Support Wires Properly
Do not let exposed wires dangle. Properly securing wires prevents damage and accidental fires.
-
Use coded metal conduit or wiring hangers designed for the wire gauge.
-
Position hangers every 4.5-5 feet along wire runs.
-
Ensure hangers grip wires firmly without damaging insulation.
-
Maintain at least 1 inch spacing between wires for heat dissipation.
Use Safe Connections
Improper wire connections can lead to dangerous overheating and sparks.
-
Choose twist-on wire connectors or lever nut connectors rated for the wire gauge.
-
Twist connector completely onto wires until tight.
-
Secure connections with electrical tape for vibration protection.
-
Make sure wire junction boxes are accessible for future maintenance.
Install GFCI Outlets
Exposed wiring requires GFCI (ground fault circuit interrupter) outlets for protection.
-
GFCIs shut off power quickly if a ground fault is detected.
-
Use GFCI breakers if you have metal conduit, or GFCI outlets if not.
-
Position GFCI outlets within 6 feet of all exposed wires.
-
Test GFCIs monthly by pressing the "Test" button to ensure they trip properly.
Check Your Work
Always double check your work before turning power back on.
-
Inspect all connections for tightness and insulation damage.
-
Verify proper clearance between wires.
-
Check that all junction boxes are sealed.
-
Have an electrician inspect the installation if possible.
With proper materials and installation methods, you can safely run exposed wires to add an industrial look. Always prioritize safety over aesthetics when working with electrical systems. Hire a professional electrician if you lack training on safe wiring techniques.